Controlling dangerous things safely

Fire When Ready – A Pyro-Electric Safety Primer is a great document on issues around controlling dangerous things electrically. The document tells the techniques used on pyro/fireworks electrical control. Quite similar practices are used in other control applications where potentially dangerous things are controlled using electrical circuits or electronics.

8 Comments

  1. Garbina says:

    Great! post! ;-)

    Reply
  2. dududukkkkkkk says:

    Controlling dangerous things safely Tomi Engdahl’s ePanorama blog Pretty nice post. I just stumbled upon your blog and wished to say that I’ve truly enjoyed surfing around your blog posts. In any case I will be subscribing to your feed and I hope you write again very soon!

    Reply
  3. Tomi Engdahl says:

    Pyrotechnics sequencer with wireless trigger
    https://hackaday.io/project/27156-pyrotechnics-sequencer-with-wireless-trigger

    This device will light fireworks in sequence with a wireless remote. Version one will have 64 positions

    With it, he will be able to setup all the pyros during daylight, then arm the system at show time and sit back and enjoy the show at a safe distance with the rest of the party using a simple remote to ignite fuses in sequence.

    Reply
  4. Tomi Engdahl says:

    Inside a special effect pyrotechnic “robotic”.
    https://www.youtube.com/watch?v=DUhucC-U8ys

    If you’ve ever seen a film where electrical things like spaceship control panels and robots were blowing up and shooting out showers of sparks, then this is probably what was being used to create the effect. It’s a simple pyrotechnic device that is designed to shoot out a shower of sparks when triggered.

    Reply
  5. Tomi Engdahl says:

    HOMEMADE FIRING SYSTEM – How It’s Made – Nicolas Salenc PBP
    https://www.youtube.com/watch?v=qGiYzITicHk

    4 cue homemade firing system!

    Reply
  6. Tomi Engdahl says:

    Aladdin Lamp Shoots Flames With A Snap Of Your Fingers
    https://hackaday.com/2020/05/13/aladdin-lamp-shoots-flames-with-a-snap-of-your-fingers/

    Despite their dangers, even Marie Kondo would not convince us to abandon flamethrower projects because they literally spark joy in us. To make this flame shooting Aladdin lamp [YeleLabs] just used a 3D printer and some basic electronics.

    The lamp body consists of two 3D-printed halves held together by neodymium magnets. They house a 400 kV spark generator, a fuel pump plus tank, and a 18650 Li-ion battery.

    https://hackaday.io/project/171349-aladdins-hand-sanitizer

    Although they proclaim that the device is a hand sanitizer it is probably safer to stick to using soap. The project still goes on the list of cool flamethrower props right next to the flame shooting Jack-o-Lantern.

    https://hackaday.com/2019/05/10/its-never-too-early-to-prepare-for-halloween-with-flamethrowers/

    Reply
  7. Tomi Engdahl says:

    Programmable firework firing system with remote
    https://hackaday.io/project/173578-programmable-firework-firing-system-with-remote

    This project is using the Arduino Nano and WS2811 LEDs for a 50 channel (cues) remote firework firing system.

    Reply
  8. tomi says:

    Feel free to add link to my page.

    Reply

Leave a Comment

Your email address will not be published. Required fields are marked *

*

*