Intel Takes a Step Back In The Internet-of-things

https://www.open-electronics.org/intel-takes-a-step-back-in-the-internet-of-things/

A few weeks ago,  Intel has quietly discontinued its three SBC boards, the Joule, Edison and Galileo. These pretty much represented the presence of x86 chips in the IoT market.

SBCs are perfect for the IoT space. So, why would Intel kill off its SBC boards?

It could be read as an admittance that its IoT strategy has not been working too well.

The Internet’s favourite theory for the discontinuation, is that Intel didn’t really support it’s ecosystem.

The Pi and Arduino, the two most popular SBC families, can boast colossal communities and close collaboration with the hardware makers.


2 Comments

  1. Tomi Engdahl says:

    The End of Arduino 101: Intel Leaves Maker Market
    http://hackaday.com/2017/07/25/the-end-of-arduino-101-intel-leaves-maker-market/

    This looks like the end of the road for Intel’s brief foray into the “maker market”. Reader [Chris] sent us in a tip that eventually leads to the discontinuation notice (PCN115582-00, PDF) for the Arduino 101 board. According to Intel forum post, Intel is looking for an alternative manufacturer. We’re not holding our breath.

    We previously reported that Intel was discontinuing its Joule, Galileo, and Edison lines, leaving only the Arduino 101 with its Curie chip still standing. At the time, we speculated that the first wave of discontinuations were due to the chips being too fast, too power-hungry, and too expensive for hobbyists. Now that Intel is pulling the plug on the more manageable Arduino 101, the fat lady has sung: they’re giving up on hardware hackers entirely after just a two-year effort.

    Reply
  2. Tomi Engdahl says:

    Microcontroller-class x86 gives way to ARM
    http://www.eetimes.com/document.asp?doc_id=1332098

    Intel has apparently ended efforts to drive its x86 architecture into microcontroller-class chips and end nodes on the Internet of Things. Analysts generally applauded the move, although they noted it reflects in part on a market for wearables that has not emerged as fast as predicted.

    Multiple reports said Intel has ended sales of Currie and other IoT boards using its Quark processors. However, the company did not directly respond to questions about Quark, a stripped down x86 chip CEO Brian Krzanich announced in his first keynote at the company’s annual developer conference.

    As recently as last August, Intel presented a paper describing its D2000, a 32-bit x86 processor that consumed as little as 35 milliwatts in active mode. At the time the engineer describing the device at Hot Chips said Intel had plans “to scale [Quark] from MCUs to right below the Atom X1000 for Linux with lots of implementation options in cores and SoCs.”

    At one time, Intel fielded as many as three Quark chips — the SE, D2000 and D1000. All were spins of the original synthesized Pentium-class core Krzanich announced in 2013 as a 32nm part, one-fifth the size and one-tenth the power of Intel’s Atom core.

    Intel rolled out several IoT boards using Quark chips, including several compatible with Arduino starting in October 2013. An Intel spokesman said the company remains committed to supporting the DIY maker movement.

    “IoT remains an important growth business for Intel and we are committed to IoT market segments that access, analyze and share data. These include retail, industrial, automotive and video, which will drive billions of connected devices,” the spokesman said, suggesting the company will focus on Atom-based gateways as its new low end.

    Reply

Leave a Comment

Your email address will not be published. Required fields are marked *

*

*